Powder-filled capsule shell sorting tray

Put the powder-filled capsule shells into the “powder-filled capsule shell sorting tray”, about 300 capsules each time. Put the capsule cap into the “capsule cap sorting tray”, about 300 capsules each time. The sorting tray is made of plexiglass plate, and there are many round holes in the shape of a funnel, the diameter of which corresponds to the diameter of the capsule number. At this time, the capsule shell of the vibrating worktable moves steadily back and forth, so that the pellets enter the plate hole one by one.

About 30 seconds, the powder-filled capsule shell and capsule high shear mixer granulator will drop into the round hole with the opening facing upward. In case of individual openings facing downwards, the caps of the capsules can be gently pressed down to pull out.

Hold the powder capsule shell connecting plate horizontally (shown at the end of the picture, it has been prepared at random, and there are round holes in the connecting plate), gently push in the lower part of the sorting tray, and the powder capsule shell in the sorting tray is It will fall into the round hole of the connecting plate, and then take out the connecting plate. In the same way, remove the capsule cap with the capsule cap connecting plate.

A medicinal powder square plate with a bottom area of ​​500×500mm and a height of about 10mm on four sides can be prepared in advance. The powder is filled in, and the powder capsule shell connecting plate is placed flat in the powder square plate. Then put the randomly equipped plexiglass frame on the powder capsule receiving plate, put the powder into the frame with a small bucket, and scrape the edge of the frame to fill the powder and scrape off the excess powder.

Use the randomly equipped capsule cap cover plate (shown at the end of the picture, the cover plate has a round hole), put it on the capsule cap cover plate, there are alignment holes, it is easy to place. Turn over the cap connecting plate of the capsule so that the opening of the capsule faces downwards, and put it on the powder-filled capsule connecting plate that has been filled with powder. There are also alignment holes for easy fitting.

Put the nested capsule board into the cavity under the “capsule cap forming board”, pull the “pressing rod” down by hand and put it in place. There is no need to be careful of excessive force, because the positioning mechanism controls the pressing down height. Take out the sleeved capsule plate, pour out the capsule, and finish filling. You can cycle to the next board.